Piston Ring Options

This Forum is for Puch Motorcycle related topics.
Post Reply
Joined:Sat Aug 10, 2019 1:17 am
Location:Atlanta, GA
Piston Ring Options

Post by PuchRider » Mon Aug 19, 2019 11:27 am

Hey all, I am planning to refresh my 1964 Allstate 250 with new seals and gaskets. I am considering replacing the rings and honing the cylinders, especially after seeing that the front cylinder was installed backwards (ring gap visible from the intake). Bike runs strong though and will check the compression and for defects on the cylinder walls and pistons.

I've read other threads and see MotorWest is likely my best option, being in the United States. Shipping from RBO is 42 Euros. I have found 45 x 2.5 mm rings manufactured by Caber available here. The site says they are compatible with Puch engines. Would this be compatible with our 250s? It looks like it will work with the pin. Not sure if there is any other measurement needed to make sure it will work. What do you guys think? Thanks!
Joined:Wed Apr 13, 2011 12:33 pm
Location:Toronto (Leaside), Canada

Re: Piston Ring Options

Post by bocutter » Mon Aug 19, 2019 12:47 pm

PuchRider wrote:
Mon Aug 19, 2019 11:27 am
What do you guys think?
I think you could just remove the 4 nuts holding the jug, raise it up enough to access the wrist pin, then rotate the piston. Then proceed as you wish. ;)
'61 Puch DS60 (Allstate Compact) - sno-bike
'66 Puch 250 SGS - off the bench Aug '19
'87 BMW K75s - daily user

My name is Ed
Post Reply