Sounds like the clutch has stuck through standing??

Hello ,I have many years experiance with Puch SG,SGS ,SVS's on 2 occasions i have found a dragging clutch was down to a small hairline crack in the castings where the 2 securing bolts are , the result was when pulling in the clutch lever the casting moved with the loss of real clutch action! hence a...

[image] My 'Allstate but now a Puch again My 'Allstate but now a Puch again [/image]Hello Frank, good to know there is another Puch (Sears) in the UK , Back in February i bought a 'Allstate(American import) from a dealer near Coventry but it was missing seat, front mudgard, headlight/shell,chrome ta...

Hello , Bernie from the 'Adler to Zundapp Club' also the UK puch split single register go to the British Two Stroke Club web sit for info on getting your bike registered for a V5. Bernie.

Hi! there, Bernie from the UK, your washer is from drive side of the crankshaft there are 2 of them ,they fit either side of the crank seal then comes the 2 crank bearings 1 inner, 1 outer. Tip do not removed crank shaft any way other than using a hydraulic press!

Hello The wiring for the dynamo is as follows The 3 terminals on the plastic dynamo board should have numbers 30/51.......61........15 ......... wire from the 30/51 (red) goes to terminal 30/51 in the headlight switch board from there it goes to the positive terminal battery .... Terminal 61 (blue w...

Hello

Hello There!! wiring to the dynamo Puch wise (I think sear should be the same for the sears) 3 terminals on the dynamo plastic board )should be numbered 30/51......61...........15 which means terminal 30/51( Should be red) comes from the positive term battery up to the headlight switch 30/51 and the...

Hello greetings from the UK, you dont say how long it has been running before it dies?? if when you have just started it,if it dies probably source is gas starvation However if its been running on a ride say after 15 minutes the problem occurs, then is probably coil or condenser or maybe crankseals?...

Came across this picture of a PUCH 500 SGS dont know any history weather it's a factory job? or a one off special talented engineer? but the engine is a 500cc flat twin 4 /stroke which also powered the Steya+ PUCH 500 (Fiat) https://berniesbikeshed.files.wordpress ... .jpg?w=720